Key takeaways
- Fraxel pain depends first on the laser type (ablative CO2 or non-ablative) and then on the energy and density your provider chooses.
- Pain scores: in a study of full-face non-ablative Fraxel, average pain was 6.95 out of 10 without cooling and 4.0 with a cold-air device.
- After a non-ablative session, a mild sunburn-like sensation usually lasts about an hour, and swelling settles in 2 to 3 days.
- CO2 fractional: swelling can last up to a week. Clusters of small blisters need a call to the clinic right away, whatever the day.
If pain is your biggest worry, start by asking which kind of fractional laser you're getting. A CO2 fractional laser removes tiny columns of the skin's surface and tends to hurt more, while a non-ablative laser like the original 1,550 nm Fraxel leaves the surface intact and is usually milder. Within either type, a higher energy or a denser pattern of laser spots means more pain and swelling.
Does Fraxel Hurt More Than a CO2 Fractional Laser?
Does Fraxel Hurt More Than a CO2 Fractional Laser?
Yes, the ablative CO2 type is typically the more painful of the two. Here's why. A non-ablative laser leaves the top layer of skin (the epidermis) in place and heats thin columns in the layer below (the dermis). A CO2 fractional laser vaporizes very fine channels through the surface and reaches deeper into the dermis. Whether the surface is opened changes both how the session feels and how long recovery takes.
Non-ablative resurfacing is described as minimally painful, and some people don't need any numbing for it. Ablative treatments are typically more painful. Cold packs right after the session can ease discomfort.
| Non-ablative fractional (e.g., 1,550 nm Fraxel) | Ablative CO2 fractional | |
|---|---|---|
| Skin surface | Left intact | Tiny open channels |
| Pain during treatment | Usually milder | Usually stronger |
| Swelling afterward | Usually minimal, 2 to 3 days | Up to a week |
| Peeling and crusting | Light flaking | More peeling, some crusting |
Does Fraxel Hurt More Than a CO2 Fractional Laser?
Fraxel Pain Scores: What Have Studies Measured?
Fraxel Pain Scores: What Have Studies Measured?
In a study of 20 people having full-face non-ablative Fraxel, average pain was 6.95 out of 10 without extra cooling.
When the same people had a handheld cold-air device added, the average dropped to 4.0. Nearly everyone in the group said the session hurt less with cooling.
For the CO2 type, 30 adults treated around the eyes for fine lines rated their pain at an average of 5.67 after a numbing ointment had been on for 1 hour. All of them completed the treatment. That study only looked at the eye area, so it doesn't translate directly to a full-face session.
Fraxel Pain Scores: What Have Studies Measured?
At a glance, the CO2 number looks lower. Keep in mind the two studies used different areas and different numbing and cooling, so the scores can't be compared head to head.
Why Fraxel Pain Can Change From One Session to the Next
Why Fraxel Pain Can Change From One Session to the Next
If your second session hurt more than your first, the first thing to check is whether the energy or the density went up. Pain during fractional treatment depends on how much energy is delivered to the skin.
A split-face study of 30 Asian women tested different settings on each side of the face. The side treated with a higher density or a higher energy had more pain, redness, and swelling. Satisfaction rose only with higher energy, and higher density was more likely to bring swelling, redness, and dark spots.
That's why, if pain worries you, it helps to ask how the energy and the number of sessions will be split, rather than simply packing in more density. Results differ from person to person.
Who Should Hold Off on a CO2 Fractional Laser?
Who Should Hold Off on a CO2 Fractional Laser?
Some situations call for postponing an ablative CO2 treatment. Bring these up before your session:
- An active bacterial skin infection or a cold sore (herpes simplex) in the area to be treated
- Taking the acne medicine isotretinoin within the past 6 months
- A tendency to form keloids or thick, raised scars
If you get cold sores often, mention it even when you don't have one now. Your provider may suggest a preventive antiviral medicine before fractional treatment.
Fraxel Downtime: How Long Does the Burning Last, and When Should You Call?
Fraxel Downtime: How Long Does the Burning Last, and When Should You Call?
After a non-ablative session, a mild sunburn-like sensation usually lasts about an hour. Swelling is usually minimal and settles in 2 to 3 days. After a CO2 fractional session, swelling can last up to a week, and peeling and crusting are more noticeable.
Serious problems are uncommon. In a review of 961 non-ablative 1,550 nm treatments, 7.6% led to a complication, most often acne-like breakouts or cold sore flare-ups. Contact the clinic right away if you notice any of the following:
- A cluster of small blisters around your mouth or nose
- Acne-like bumps spreading across the treated area
- Warmth, pus, or other signs of a bacterial infection
- Swelling that lasts longer than a week after a CO2 session
Even when pain is mild, darker skin tones are more prone to dark patches after treatment. Your skin tone matters as much as your pain threshold when the settings are chosen.
Planning Fraxel Around Your Seoul Trip
Unless you've had IV sedation that day, there's no reason to delay a flight after a Fraxel or CO2 fractional session.
One visit isn't a full course. Non-ablative Fraxel is usually done as 4 to 5 sessions about a month apart, and results build slowly over 3 to 4 months. For most travelers, a first visit works as a first session and a skin check, and the rest of the plan depends on how often you can return to Seoul.
Once you're home, you can send the clinic photos of the treated area taken in the same light and at the same angle. If you have blisters, signs of infection, or swelling that keeps getting worse, see a local doctor first rather than waiting for a reply.
Before You Book: The One Question About Fraxel Pain
Before you decide, ask: "For my concern, would you use a non-ablative or a CO2 fractional laser, and how dense would the settings be?" That one answer tells you a lot about how the session will feel and how long recovery will take. It's also worth asking how the skin will be cooled during treatment. STON Clinic is in Lotte Hotel Seoul in Myeongdong, near Euljiro 1-ga Station, and you can send that question through the consultation button on this page.
If this raised a question about your own skin
Quick bookingReferences
- Pain and preparation for ablative and non-ablative laser resurfacing — DermNet NZ — DermNet NZ
- Burning, swelling, and skin color changes after fractional laser — DermNet NZ — DermNet NZ
- When to postpone CO2 laser treatment and its side effects — DermNet NZ — DermNet NZ
- Cold-air cooling and pain during fractional laser in 20 patients — Dermatol Surg, 2005 — PubMed Central
- Density and energy settings compared side by side in 30 Asian women — Lasers Surg Med, 2007 — PubMed Central
- Pain scores for CO2 fractional laser around the eyes in 30 patients — Lasers Med Sci, 2025 — PubMed Central
- Side effects across 961 non-ablative 1,550 nm treatments — Dermatol Surg, 2008 — PubMed Central
- Side effects in 181 non-ablative 1,550 nm treatments in Asian skin — J Cosmet Dermatol, 2011 — PubMed Central
Frequently asked questions
Q. How long does a full-face Fraxel session take?
A. The laser part of a full-face non-ablative Fraxel session takes around 30 minutes. A handheld tip glides over a layer of gel on your skin while it delivers the laser. Cleansing and preparation add time, so leave some room in your schedule that day.
Q. Can I go back to work the day after Fraxel?
A. After non-ablative Fraxel, many people go back to work right away or the next day, depending on their skin and the treatment. CO2 fractional treatment is more aggressive, so recovery takes longer and swelling can last up to a week. If you have an important event, plan a CO2 session at least a week before it.
Q. Why does my skin look bronze after Fraxel?
A. A bronze tint within 24 hours of non-ablative Fraxel is a common part of new skin coming through. It can last 3 to 14 days and may come with flaking. A pinkish tone can stay for 3 to 5 days, and a moisturizer helps with the flaking.
Q. How should I use ice after a CO2 fractional laser?
A. For swelling after an ablative fractional treatment, ice packs at 10-minute intervals during the first 24 hours can help. Wrap the ice in a cloth rather than putting it straight on the skin. If swelling lasts more than a week, let the clinic know.
Q. Can I peel off the flakes after Fraxel?
A. Don't pick or peel the flakes after Fraxel. They come from old skin being replaced by new skin. A moisturizer softens them so they come off on their own. Peeling is heavier after a CO2 fractional treatment, and some crusting is possible.
Q. Is Fraxel riskier for darker skin?
A. With darker skin, the main concern is dark patches after treatment rather than pain. In 181 non-ablative 1,550 nm sessions in Asian patients with skin types III to V, dark patches appeared after 2.2% of treatments, more often than other side effects. Sunscreen and sun avoidance before and after treatment are non-negotiable.
Treatment guide for this topic
Medical information notice
This article provides general medical information and does not replace an individual diagnosis or medical consultation. View our editorial policy

Kim Simon Jang-ju Head Physician
JANGJU KIM
Head Physician Kim Simon Jang-ju practices at STON Clinic, LOTTE HOTEL in Myeongdong (from December 1, 2026).
Career / Education
- Current) Head Physician (practicing at STON Clinic Myeongdong and Beautystone Clinic Hapjeong; Myeongdong from Dec 1, 2026)
- Graduated from Kyung Hee University College of Medicine
Comments